Skip to the page

Sewer line replacement cost in Stockton: repair, trenchless and digging prices

One published guide puts sewer line replacement at $1,253 to $4,701 nationally, averaging $2,914, or about $50 to $125 per foot, with trenchless methods at $60 to $250 per foot. Here is what moves the price.

Last changed

Get my quote

Four factors that drive sewer line replacement cost

Sewer line replacement usually costs $1,253 to $4,701 as a whole job in a published national guide, with a $2,914 average, and usually $50 to $125 per linear foot (possibly up to $250). A line under a slab is published at $300 to $350 per foot. The plumber quotes the real price after a camera inspection. For the work itself, start with our page on sewer line repair and replacement, then use the ranges here to read your quote.

What is the average cost to fix a sewer line?

The published national average for a sewer line replacement is $2,914, with a typical range of $1,253 to $4,701. A small spot repair can cost less, and a long replacement with restoration can cost far more. The table below separates the common jobs so you can match your quote to the work.

JobPublished price (guide only)
Whole sewer line replacement, typical total$1,253 to $4,701, average $2,914
Per foot, general$50 to $125 usually, up to $250
Per foot, basement line, no ground excavation$60 to $250
Per foot, trenchless$60 to $250
Per foot, pipe bursting$60 to $200
Per foot, cured-in-place lining$80 to $250
Per foot, line under a slab$300 to $350
Camera inspection$100 to $500
Permitabout $200, varies by city

A broken sewer line repair and a collapsed line are priced in the same per-foot terms, and a section sagging into a low spot, often called a belly, is often fixed by replacing that section, so it is priced by length too.

How much does it cost to replace 50 feet of sewer line?

Using the published general per-foot range of $50 to $250, replacing 50 feet costs roughly $2,500 to $12,500 before restoration. That is arithmetic from published rates, not a quoted job price. A straight run in open ground costs near the low end, and a run under a driveway or slab costs near the high end.

Add the cost of putting things back. We found no published restoration figures, so ask each business for them. Always ask whether the quote includes restoration, because a low line price with no restoration can end up costing more.

Is trenchless sewer line repair cheaper than digging?

Trenchless costs about $60 to $250 per foot, against $50 to $125 usually for digging, but it can lower the total by avoiding damage to the yard, driveway or foundation. Digging is usually cheaper upfront and can carry higher restoration costs. Trenchless does not suit every pipe.

Trenchless methods include pipe bursting, which pulls a new pipe through the old one, and lining, which cures a new pipe inside the old. Neither usually suits a pipe that is badly collapsed or misaligned, and some jobs still need digging at access points. For the detail, see trenchless versus traditional sewer line repair and trenchless pipe burst.

What drives the cost of a sewer line replacement?

Length, depth, access, pipe material and the method decide most of the price. Where the line runs matters, because a run under a driveway, patio or foundation costs far more than one through a lawn. Corrosion, cracks and roots in old pipe can force a full replacement rather than a spot repair.

  • Length and depth. More feet and deeper trenches mean more labor and equipment.
  • Material. The pipe material changes the price, so ask which pipe is quoted.
  • Digging and access. Tight crawl spaces and slabs raise the cost.
  • Labor. Plumbers are published at $45 to $200 an hour; see plumber hourly cost.
  • Permit. San Joaquin County's building page lists water and sewer lines among the work needing a permit, so ask who arranges it. California requires a licensed contractor when a job needs a permit or totals $1,000 or more.
  • Surprises. Unexpected underground conditions can change the quote after work begins.

How much does it cost for a plumber to snake your sewer line?

Unclogging a drain, including snaking, is published at $100 to $500. Hydro jetting is $350 to $600, averaging $475. If a snake keeps clearing the same blockage, a camera inspection of $100 to $500 shows whether the pipe is damaged, which would point toward repair instead.

A sewer smell or repeated backups is often the first sign that cleaning is not enough. Our page on a plumber for sewer smell explains what a plumber checks, and hydro jetting cost compares the cleaning methods in detail.

Questions people ask

How long does a sewer line replacement take?

Trenchless jobs can take a day or less, while digging a longer line can take several days including restoration. A camera inspection beforehand helps the plumber give a realistic schedule. Ask when your toilets and drains will be out of use.

Should I get a camera inspection first?

Yes, in most cases. It costs $100 to $500 and shows the cracks, roots, sagging or collapse in the line, so you pay to fix the actual problem. Ask the plumber for the recording and the location of the problem in feet.

What should I ask before I hire someone for sewer line replacement?

Ask which method they recommend and why, whether restoration is included, who pulls the permit, and what could change the price. Get the quote in writing. California contracts must show the contractor's license number, and you can check it at cslb.ca.gov.

Do I need to be home for the work?

Someone usually needs to give access on the first day and be reachable while the line is open. Ask where equipment will sit and whether water will be shut off.

Sources

Last changed